XC17S200APDG8C DataSheet
DATASHEET
XC17S200APDG8C Description
After Preset Mode inputs have been changed to one of the modes, the next positive-going clock transition changes an internal flip-flop so that the countdown can begin at the second positive-going clock transition. Thus, after an MP (Master Preset) mode, there is always one extra count before the output goes high. Figure 1 illustrates a total count of 3 (8 mode). If the Master Preset mode is started two clock cycles or less before an output pulse, the output pulse will appear at the time due. If the Master Preset Mode is not used, the counter jumps back to the Jam count when the output pulse appears.
XC17S200APDG8C Features
(5) Nominal capacitance The capacitance is expressed in three digit codes and in units of pico farads (pF). The first and second digits identify the first and second significant figures of the capacitance. The third digit identifies the multiplier. R designates a decimal point.
XC17S200APDG8C Applicatioins
The low-side XC17S200APDG8C driver provides an output pin 8 (FLT) to indicate a high- side (XC17S200APDG8C) or a low-side (XC17S200APDG8C) fault. This output pin is an "open-drain" output. The XC17S200APDG8C low- side driver fault indications are similar to the XC17S200APDG8C high-side driver indications as outlined above. A "graphic" logic diagram of the chipset´s FLT function is presented in Fig.4. Note that this diagram presents the logic of this function at the "low-side" XC17S200APDG8C driver and is not the actual circuit. It describes the combined logic of the "fault logic" and "hi-side fault sense" blocks in both the XC17S200APDG8C and XC17S200APDG8C as shown in Fig. 2 and 3.
Relate Parts
Part Number
Quantity
Manufacturer
Date Code
Description
Pricing
10241
11+
PARAMETER Reference Voltage Section Fb Voltage
13752
11+
The floating-point register file is made u
13848
Hardware Reset, active Low. Provides a hardware me
5208
A high on the MASTER RESET (MR) sets all the cont
14048
Addresses and chip enables are registered at risin
16717
The XC5200 Field-Programmable Gate Array Family i
5239
The CM8560 is a low cost linear regulator designed
15491
Wiper position programming defaults to midscale a
17695
The CS5381 uses a 5th-order, multi-bit delta-sigma
8886
The mounting area was reduced by mak- ing the tw
13759
The A-to-B enable (CEAB) input must be low in ord
17911
via an RF or an infrared transmission medium upo
4950
Note 2: The maximum power dissipation is dictated
4838
The BRT (Bias Resistor Transistor) contains
4726
The deserializer stays in lock until it cannot de
8636
(1) Dolby Available only to licensees of Dolby La
15385
Figure 1 shows a typical soldering profile for th
14663
Programmable low and high gain (<2 dB resoluti
19152
For example, if a block of data is to be transfer